Hear how to keep nails from popping out, how to increase the height of outdoor dryer vents, and more.
How to prevent nail popping
The homeowner’s house was built in 1954 and has nails protruding from the rock slabs.
she asks: “How can I fix this?” Can I re-drill the nails? ”
First, re-driving the nail will only fix it temporarily. They will eventually pop out again. But why is this happening?
There is a lot of movement in a house, such as doors slamming, people walking, etc., and all these movements cause vibrations. Over time, the vibration will cause drywall nails to fall out.
To solve this problem, remove the nail and replace it with a screw, because it is better to use a screw. Nails were used because there were no drywall screws in his 1950s when this house was built.
You can’t just remove the nail and replace it with a screw before checking if the nail is centered or close to the stud. It may be the cause of the stud popping out.
Therefore, it is recommended to use a hammer and finishing nails to hammer the drywall until the center of the stud is found. Once you’ve found the center and pulled the nail out, drive one or two drywall screws an inch or two above the old nail hole. It is now firmly fixed.
After replacing the nail with a drywall screw, put some joint compound over the head of the screw and in the old nail hole, let it dry, sand it down, and start over. Fill and dry, then paint.
Here is a how-to video on repairing and replacing drywall nails.
The screws will hold tight so I don’t think you’ll ever have to do this process again.
How to Raise the Air Vent on an Outdoor Dryer
The homeowner’s dryer vent is located under the exterior wall and brick veneer. It is placed about 1 inch from the ground, not 12 or more. He has trouble getting water into the vents.
“Do you have any recommendations?” he asks.
When the vent was first constructed, it may have been the correct height above the ground, but over time, grading and landscaping may have been added, bringing the vent closer to the ground. there is.
For the dryer vent to work efficiently, it should be as short as possible. Therefore, it is not recommended to change the route and go through the eaves.
We recommend raising or extending the vent or digging around the vent to create more space. You can also gently roll and add your elbows to lift it off the ground. They made a device that rolls up to 90 degrees to help raise the outside vents. There are many options for dryer vents.
Do not use PVC pipe as it will not withstand the heat from the dryer vent. Make sure the appliances you use are manufactured for outdoor dryer vents.
For your safety, always clean your dryer vents to prevent house fires and keep your dryer running efficiently.
Ask about garbage disposal rules, how to fix a toilet that doesn’t drain, how to put underlays on tile floors, and more.
What you can do at the garbage dump
Homeowners and their wives continue to disagree over whether meat scraps can be dumped in landfills. We also do septic tank treatment.
He said, “Can you settle this argument?”
There is no problem with installing a garbage disposal with a septic tank. But some septic tanks are very good and some are very marginal. This has a significant impact on the functionality of treatment equipment and the waste to be treated.
So what can you put in a landfill?
When it comes to garbage disposals, we want to use them sparingly rather than putting everything in the trash. I would like to avoid placing large objects on it.
The answer to your question is yes, but meat should be small pieces only and not overfilled.
Make sure you use and maintain your garbage disposer correctly. We recommend using cold water to flush the waste down the drain and not putting anything in the garbage disposal to flush it out.
Use this trick if your garbage dump is full!
How To Solve Toilet Water Flow Problems
One homeowner struggles to flush his toilet all the way. She said she had to hold the handle down until the bowl was washed out.
She wants to know, “Why is this happening and how can I fix it?”
There are two reasons why she has this problem. One is that there isn’t enough water in the tank so it stops before it reaches about half an inch below the overflow her tube. That’s where I want to adjust.
Then, when the handle is pushed down, make sure the flapper stays open to allow a flushing action and then closes. If the chain is too short or too long, it will not happen.
Another cause is clogged drains. Obstructions prevent the flushing action from occurring as water entering is resisted.
That’s probably the first problem.This is a very common fix and there are lots of great fixes repair kit there. Do it quickly so you don’t waste water.
Toilet repair may not be the most attractive form of home improvement, but keeping a functioning toilet in good condition for the long term is very important.
References: Guide to each part of the toilet tank
How to attach underlay
A homeowner wants to put a quarter-inch underlay on the tile floor.
he asks: “Do I need to fix it with nails or screws?” What do you use? ”
No need to nail or screw. must be glued. Do your research to find the right adhesive you need, depending on the material you’re using. Most of the time, put it in a bucket and use a notch trowel to attach the right amount.
Always read the instructions and make sure you are using the recommended notch trowel size. Many people don’t realize that there needs to be a correlation between notch trowel size and adhesive to work well.
Use leftover blocks, bricks, or heavy objects to add a little weight to keep the floor from moving when you put it down. Leave it overnight to dry and harden.
There are multiple options for the substrate. One option is a self-leveling underlay. It’s really like thin concrete. Apply a thin coat over tile to create a smooth, flat surface for laying vinyl floors.
References: Gluing and Nailing Hardwood Floors
best new product
|The StyleWell Parker Mill 4-Piece Metal Patio Set provides durable, long-lasting, dependable outdoor furniture. Learn more>>|
Preparing the push bloom paint— Before painting a room, it is important to clean the walls and ceiling to remove all dust, dirt and cobwebs. Here’s a quick and easy way to do this: Wrap a towel around the head of the broom and secure it with a binder clip or pinch him clamp. Then lightly mist the towel with water. Then use a broom wrapped in a towel to wipe down the walls and ceiling. A damp towel will trap dust and dirt, leaving a clean, paint-ready surface. This tip is also great for removing joint compound dust from newly sanded drywall joints.
Easily accessible garden tool storage—Most people store their lawns and gardening tools in their garages or sheds, just standing upright and leaning against corners. Other than it’s a little messy and hard to grab a tool without flipping another one, it doesn’t really matter. So here is a very simple solution to this problem. Take 3 concrete blocks and stack them where you want to store your tools. Finally, he has two deep compartments for storing long-handled tools. The blocks are heavy enough that they won’t topple over, no matter how many tools you put in them. If you don’t have enough headroom, you can use two blocks to lift the tool out. This way, the tools are out of the way and you have a clean spot that is easily accessible and you don’t have to worry about the tools tipping over.